Follow Me On Pinterest justwritedesign - Julie
Subscribe by Email
Loading
Archives
Categories

Posts Tagged ‘brayer’


A big congrats to Lynn, the newest Featured Stamper (FS788) on Splitcoast! She has wonderful gallery full of scrap book pages & I chose THIS as the base for my card. I used a similar layout & similar colors, but used different images & dies, & made mine a bird birthday card.

For my card, I bartered a piece of white card stock w/ the Distress inks, going from light at the top to dark at the bottom. After heat setting, I placed it in my Misti & stamped the bird bg w/ the Versaclair ink then clear embossed it. I used a bit of water to remove a little ink on the birds, so they would show up a little better. I wanted a little sparkle, so I spritzed it w/ a clear shimmer spray before die cutting it w/ the scalloped mimi slimline die. It was a little too long so I trimmed off the top & bottom a tiny bit. The bird was stamped, colored & die cut, w/ a couple of extra blank birds behind it to elevate it a bit. The Birthday part of the greeting was die cut out of thick white card that I sponged on the same colors I used in the bg. Some Versamark was rubbed over it then it was clear embossed twice to give it a shiny, enameled look. A few clear dew drops were added to the bg. A little clear Wink of Stella was added to the bird’s tail feathers.

Here are the Copics I used:

Thanks 
so much for stopping by! 

 

 

Supplies:

Stamps: : Rubbernecker Stamps: Bird/Rose Bg Strip, Birds set
Paper:  Staples 110# white
Ink:  Distress inks twisted citron, peacock feathers, Versamark, Versaclair warm breeze
Accessories:  Rubbernecker Stamps: Birds, Mini Slimline Scallop stitch Square Stitch, Birthday Script w/ Shadow dies,  Crossover II, Misti, clear dew drops, clear embossing powder, Tsukineko shimmer spray, clear Wink of Stella



For the Splitcoast Inspiration Challenge (IC833), we’re going to a wonderful Lighthouse Pinterest Board where I found THIS lovely picture.

For my southwest card, I started w/ a background I made quite a while ago. I thought the purples & oranges were good colors for a desert sunset scene. The bg was done by smooshing the Marvy metallic markers onto a rubber brayer, spritzing w/ water & rolling it over a piece of white card. If I remember correctly, I did it once w/ the yellow, orange & silver colors & again w/ the purples & silver. The hills & cactus plants were die cut out of a few shades of purple & I used part of the leftover orange areas for the cowgirl, cowboy & roadrunner. They were also popped up on foam to give them a little depth.

Thanks 
so much for stopping by!

 

 

Supplies:

Stamps: none
Paper:  Staples 110# white, several shades of purple
Ink: none
Accessories:  Rubbernecker Stamps: Rectangle Stitch,Southwest Hills, Cowgirl & Cowboys, Western Animals, Cactus dies,  Crossover II, Marvy Metallics markers, rubber brayer



Congrats to Angie, the newest Featured Stamper (FS751) on Splitcoast! She has a beautiful gallery & I chose THIS card to case. I kept the colored bg w/ the lattice die cut on top & the flower in the corner, but I used different images & dies, different colors & a stamped flower instead of a die cut flower.

For my card, I used a brayer & a rainbow pad to create my bg & I used a slimline lattice die for the cover. Instead of cutting it lengthwise, I turned it sideways & cut 2 short pieces to put side by side, horizontally. I knew the greeting strip would cover the join, so I didn’t even worry about that. The sides were trimmed down a bit to fit & I added a lime green layer behind it. The peony was half die cut/half fussy cut, using my out of the box method.

Here are the Copics I used on the peony:

Thanks so much for stopping by!

 


Supplies:

Stamps: Rubbernecker Stamps: Poetic Peonies  
Paper:  Staples 110# white, X-Press It, lime green
Ink: Memento tuxedo black, Kaleidacolor bouquet
Accessories:  Rubbernecker Stamps: Poetic Peonies,Rectangle Stitch,Slimline Geometric Squares dies, Crossover II,MISTI, Copic Sketch Markers,  brayer