Follow Me On Pinterest
Subscribe
Subscribe by Email
Archives
Categories

Archive for the ‘Magic Foam’ Category

Julie Warner – http://thewritestuff.justwritedesigns.com
What a fun site for today’s Inspiration Challenge (IC395) on Splitcoast! Since it’s almost the 4th of July, I went with this fun Fireworks Outfit.

The images are all from DRS Designs. And for my July 4th tribute card, I’m using this wonderful Freedom Cannon. After coloring w/ Copics, I die cut it and attached it to a red rectangle. The red rect. was embossed w/ a star border down the left and a stripe folder on the right. On the royal blue background, I inked just the fireworks part of the Freedom Cannon and stamped it tone on tone. The sentiment was inked w/ 2 colors of ink and die cut in a banner shape. A little stickles was added to the fireworks for a little sparkle. The finished card is 5.50 x 4.25.

Here are the Copics I used:

Julie Warner – http://thewritestuff.justwritedesigns.com

Thanks so much for stopping by! If you haven’t yet, be sure to check out the DRS Thursday Challenge. This week things that start w/ the Letter B! Just link up your creation on the DRS Blog and you’ll be entered to win (DRS images are not required).

 

Julie2 sig
Supplies:

Stamps: DRS Designs – Freedom CannonLet Freedom Ring
Paper: white, red, royal blue
Ink: Memento tuxedo black, bahama blue, Colorbox lipstick red fluid chalk
Accessories:   Copic markers, stickles, Spellbinders labels 18 & lacey pennant dies, Cuttlebug embossing folder (Measure by Measure set), Quickutz embossing folder (Nautical set)

 

 

Pin It


The greeting is actually the negative piece left after running the die thru the CB. I sponged the edges w/ the green ink. I cut a frame of the cool carib. and attached underneath, then attached this to the olive layer. Since the c.carib. was open in the back, the olive shows thru the letters. I used the nestie rectangle on a vanilla piece and used the frame instead of the actual rectangle and set my greeting layers inside it.

The bg was done w/ magic foam. It’s basically the kid’s dense foam they make blocks and shapes. You hold it against a light bulb for about 30 seconds then press it against something; a stamp, an object, a piece of mesh. It retains the reverse image until you reheat it. Don’t use your heat gun, it will melt the foam. I pressed mine against some of those molding mats. Then I inked it w/ the lt brown and stamped onto the vanilla. I used markers & a blender to add some color and also sponged a little of green ink around the edges. Then I used the CB mesh folder on it.

The buckle is also a nestie die. I added the ribbon and layered a few times. I stamped the big leaf (Magenta), colored it, outlined it w/ a brown gel pen then cut it out. I stamped the smaller leaves (SG) w/ the green and Neptune inks and cut them out. They’re all layered then the greeting was attached w/ foam tape.

Julie2 sig
Supplies:
Stamps: Studio G, Clearsnap molding mats, Magenta
Ink: Ancient Page lt brown, leaf green and Neptune
Accessories: ribbon, foam tape, Nestabilities rectangle & ladies buckle die, Cuttlebug thanks die & mesh embossing folder, magic foam, markers, brown gel pen

Pin It
May 2017
S M T W T F S
« Apr    
 123456
78910111213
14151617181920
21222324252627
28293031